NOTE: Issue the ver -v command to view information about your control system. For older 3‑Series control systems, these settings may need to be updated. NOTE: The syntax for each command is provided at the end of this section.įor 4‑Series control systems and 3‑Series control that have been recently purchased or restored to factory defaults, the ssl and authentication commands will be properly configured to use the HTML5 Web XPanel feature. The three commands to control these settings are ssl, authentication, and optionally userpageauth. The control system must require authentication to access resources and must enable secure, encrypted communications.
Authentication CommandsĬrestron has set high security standards for using the HTML5 Web XPanel feature on the control system. For more information, refer to Add or Remove HTML5 Web XPanel Support and Add XPanel to Custom (Non‑Template) Project. You will need to change the WebXPanel library configuration if you change the WebSocket port from the default value. The securewebsocketport console command can change the default port number. A new service port is made available on the control system to support secure WebSocket communications that are supported in browsers and by the CH5 WebXPanel library. HTML5 Web XPanel is hosted in a web browser and, as a result, can not communicate to the control system via TLS sockets like other touch screens. For example, if the port was changed to 8443, the following example URL would change from "" to "‑template/index.html". You will need to append the port to the URL to reference the project on the control system if the port was changed from the default.
NOTE: Ensure that the control system is running the minimum required firmware version or higher as described in Dependencies.
Use the following console commands to configure the control system for an HTML5 Web XPanel project deployment.